When working with a CNC flanging machine, some errors may occur. At this time, it should be noted that once there is a problem with the CNC folding machine, it should be checked. The first step of the inspection is whether the mold used by the bending machine is worn or damaged. If this phenomenon causes errors, the mold can be replaced.

In the process of checking the CNC flanging machine, if there is no damage, check the parallelism of the slider and the table. If it cannot meet the requirements of use, it can be adjusted according to the relevant standard requirements to keep the parallelism within the allowed range.

If the Angle of the CNC flanging mechanism is still a certain error, it may not be due to the problem of mold or parallelism, which may be due to the balance mechanism in the machine tool hydraulic system can not ensure that the pressure oil evenly into the left and right cylinders caused by the need to adjust.

At this time, adjust the working mode of the CNC flanging machine to the point adjustment state, then remove the mold or other accessories in the machine tool, so that the slider stays on the mechanical stop, and then adjust the pressure gauge to the required pressure value.

The specific method is to compress the dial indicator head in the CNC folding machine by 3-4mm, and step on the system to increase pressure. When the press system is boosted or the system is loaded, check the dial indicator clock offset. If the specified value is reached, the operation can be stopped. Of course, in addition to the above methods, it should also be emphasized that the CNC flanging machine must be well maintained to give full play to its advantages.